日本語
X****Liu
Hard lense LEDs vs. Soft lense
866
1
Dec 19.2019, 17:44:12
Does anyone experienced failures like in pcb quality check after LEDs soft lense deformed !? Does this is failure mode associated with LED Soft lense material or the PCB soldering profile we should be focusing ??
- Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP
A****min
Dec 30.2019, 17:29:23
The machine nozzle can easily damage the soft lens so make sure your using the correct nozzle and that the part dimensions are very accurately configured.
Moisture damage is also common, don't ignore that msl3 rating on sensitive parts, lenses can actually pop off.
The oven profile should of course be correct too, I'm not sure a slightly too hot profile would damage the lens.
