日本語
****
High Power PCB
606
1
Jul 05.2019, 17:07:59
Hey guys,
I was wondering if anyone had any good ways of carrying high power across a PCB? It is a discharge circuit starting at about 500V at about 100A.
Thanks!
- Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP
A****min
Jul 09.2019, 17:30:17
I was going to say that I leave an open area in the solder mask so that you can solder tinned wire along it for high current paths, but 100 Amps is a far whack, so I would be thinking you need a bit more than that.
I would be inclined to use wires rather than a PCB trace for that.
