日本語
X****Liu
Milling/Routing on cheap chinese boards
914
1
Jan 08.2020, 17:46:19
Hello!
Since i could not find the information chances are im either to stupid to find it or they do not do it.
Does any PCB manufacturer do routing on the boards?
My design fits nicely on one of the 10x10cm boards, just once.
But i got a non-rectangular outline, it would look something like this on a 10x10 board:
I could put drill holes all around, snap the board out and go around it once with sandpaper if they do not mill "internal cutouts".
Does anyone of you have experience with that?
Greetings,
- Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP
A****min
Jan 15.2020, 10:14:25
Just put the outside dimension on your board outline layer, and they cut to this.
