日本語
****
Oval Holes - can these get fabbed without any problems?
722
1
Jun 24.2019, 09:26:56
Hey everyone,
I'm noticing a few footprints in kicad have oval holes. If I send these to get manufactured, is there any problem? Do they end up plated?
Thanks in advance,
- Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP
A****min
Jun 25.2019, 17:42:13
Slot holes usually cost extra, because they have to do the route cut separately from regular hole drilling. It's a few extra steps. So if they do make it to spec, it should be more expensive.
