PCBgogo

Electronic Project Engineer's Best Partner!
****
Solder mask working too well? (on protoboards)
534 1 Sep 21.2019, 10:45:22

I find it rather difficult to bridge solder between the holes on a protoboard, often I resort to using wire to connect pins up. I wonder if there's an easy solution or should I get protoboards without solder mask?

  • Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP
Browse
Submit
header
A****min

Sep 27.2019, 18:09:45

Brown (paper/bakelite) boards usually does not have mask, but does not have through-hole plating as well.

Approval(0) Reply

Submit
Share the Project