日本語
****
Some confusion about THT and SMD Components in PCB fabrication
703
1
Aug 12.2019, 17:30:20
Is it possible to both have THT and SMD components in one PCB design? if it is possible, is there any side effects? I'm trying to build a modified FM transmitter and I'm looking at some THT and SMD components to use in my design.
- Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP
A****min
Aug 21.2019, 09:28:56
Yes, this is done all the time. Two soldering processes (infrared/vapour phase oven for SMD & wave/manual soldering for through hole) are required.
Just try & get all the components (SMD & through hole) on the same side of the PCB as this saves quite a bit in production costs.
