日本語
****
this PLA material will be easily broken ? (3D Printer)
694
1
Oct 21.2019, 17:06:06
Hello ! i have a question..
i should print this..
this size PLA will broken easily ?
this little part receive power from micro RC Servo.
i already checked 2mm ABS is fine. (why not ABS. ABS have strain after print)
i need your experience.
Please, let me know !
- Comments(1)
Upload a photo:You can only upload 1 files in total. Each file cannot exceed 2MB.Supports JPG, JPEG, GIF, PNG, BMP
A****min
Oct 26.2019, 10:45:18
on a normal hot extruder printer, yes I would say that is pushing too thin, in part because it will also be likely to warp when being printed due to its tiny size,
If you babied it while printing just that part and ramped back the speed and heat you could print it, however its stenth would not be amazing,
Could you instead use an "eyelet screw" screwed in to the main material?
